U1342 Chrysler Auto Trouble Code

U1342 Chrysler OBD2 reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.

Remove the air filter box assembly so you can access the transmission range switch. Turn the key to the ON position, but do not start the vehicle. Move the shifter to the neutral position. Align the alignment holes between the switch and the shift lever. Insert a 5mm drill bit into the adjustment hole to verify the proper alignment for the neutral position.

U1342 Chrysler Possible Solution:

In-line Ford engines, along with those of most other manufacturers, begin the numbering of cylinders at the front and proceed in numerical order toward the back. In the V-engine design, Ford follows a similar design with the number one cylinder at the front left of the engine. In the V-6 configuration, cylinder 4 is at the front right of the engine and in a V-8, cylinder number 5 is in that location. Other manufacturers sometimes use an alternating pattern in the V-engines.

U1342 Chrysler Description For All Models :

U1342 Chrysler Trouble Repair :

The sensors receive a 5 volt reference signal from the PCM. As pressure readings change, the sensor varies the voltage and the computer reads that to determine input. In the case of a broken wire, the sensor never sees the voltage and the computer assumes a major fault. So if you get this U1342 Chrysler code, first check to make sure you're getting a good 5 volt reference signal at the sensor.

Code Search

Please fill the search bar to find Auto Trouble Code meaning.

Example: 0120